Hi All, My Mk2 Focus 1.8 TDCI (6yrs old, 82k miles) has started to make a noise when the clutch pedal is pressed partway down. The sound can only be described as a both a slight change of tone in the engine sound and also a quiet tick-tick-tick noise at the same time. It happens at the top of the

Thanks for the suggestions so far everyone. All the electrics work ins the car, lights, radio, power windows etc. Haven't got a way of testing the battery but sure thats the first thing the Greenflag guy tested, and he said battery was fine.

In this video I will show you how to change your engine oil, oil filter and air filter in Citroen 1.6 HDI or Ford 1.6 TDCI engine. This is Ford Fiesta 2009. 15. 1.6L EcoBoost SCTi and 2.0L EcoBoost SCTi: Ignition coils. 10. 2010-2014: Coil on Plug; Canister Purge Valve, Power Steering Pressure Switch (engine management) 2007-2010: Water in fuel sensor, coils, MAF (engine management, diesel engine) 10. 2.0L Duratorq-TDCi: EGR throttle, variable turbo control. 5.
Suddenly, though, out of nowhere 'ENGINE MALFUNCTION - service NOW' appears on the dash and the engine instantly cuts out, leaving me coasting to a stop. The engine would restart, however would splutter and stop when trying to pull away. After towing home and connecting my OBDII reader, I got a P0087 Fuel Rail pressure too low code.
What to look for when buying a Ford Fiesta 2008 - 2017, covering common problems to check for and overall vehicle reliability. Ford Fiesta 1.4 TDCi DPF Edge 5dr. 2011. 120,000 miles. £2,490
The Zetec S Fiesta is available with Ford's 1.6 TDCI diesel in 94bhp form, or the excellent 1.0-litre EcoBoost turbo petrol with 123bhp. The diesel is perfectly adequate, managing 0-62mph in 12.9
In today's video we will see how to remove and replace the starter motor on the Ford Fiesta sixth series, with 1.4 Zetec engine. First of all we open the bonnet of our car and start by disconnecting our battery; after which we lift the car and go to locate the starter motor, which we find near the gearbox, as shown in the video. It came up with fault code P0122. According to the internet: A P0122 code means that the the car's computer has detected that the TPS (throttle position sensor) is reporting too low a voltage. On some vehicles that lower limit is 0.17 - 0.20 volts (V).

We have big problem with Ford Fiesta 1.6 Tdci, 66kw, 2007. The vehicle will not start. THIS IS THE REPLY OF PAVLIN KOEV TO CUSTOMER: relay is in the fuse box under dash. you will get power with ignition switch turned to start position only at one of the relays- that is the starter relay. relay has 4 terminals where it is plugged to. one will have constant power and one will get power with

I have a Ford Fiesta 1.4 TDCi 2006 model. The car have been flooded and the had it cleaned and The Head Changed, Pistons and rings changed, have it checked with OBD2 scanner. Everything looks fine. The fuel pump was bad, i had it changed.

Video on how to change a crank shaft position sensor on a Ford Fiesta without a Turbo.$18-25 partGet CASH BACK for your GAS Receipts

Did'nt find much information online and a lot of people seamed to struggle to find the top starter motor bolts, there are 3 10mm socket bolts in total, 2 at Posted March 3, 2020. it could be starter motor. in the old days cars would do this when the carbon brushes wore down (or the commutator segments wore down). you would then give the starter motor a sharp tap with the end of a wheel spanner or something and that would be enough to make it work again temporarily. when you got fed up with that you
Posted November 21, 2017. Hi. I have a 2015 Mondeo Titanium 2.0tdi (x-pack) which has had a frustrating problem since I bought it. The start/stop system doesn't always work even though the correct temperature criteria is met and for the 2nd time since i've owned it the Heated front screen doesn't work. I know this is probably down to battery
.